Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: jvcr on June 20, 2022, 10:30:04 AM
-
Hello. Gamepad Elite version 1 (1698). J1 was damaged. The d-pad does not work correctly (I was restoring the connector, I had to remove it again.). On J1: 2 - DR, 3 - DU, 4 - DD, 5 - DL there is a voltage of about 1 V. J1:1 - 3,5 V; J1:8 - 5 V. Although there is no voltage on a serviceable board (1697). The measurement was carried out without a lower board with a processor, the problem is exactly in the upper board (I changed it to a serviceable lower board - everything is fine). Which element can be penetrated? Resistance is normal.
(https://i.ibb.co/xLjngNH/20220620-201252.jpg)
-
All of those pads look like the have enough trace to run a jumper wire to where they lifted, or some pad strips (ic chip solder pads)
-
hello. the question is not in the restoration of the connector, but in the appearance of voltage, which is absent on a workable board. In this state, as in the photo, I measure the induced voltage on the d-pad keys