Acidmods
Console Modding------ ( Here you can talk about your favorite Consoles ) => Xbox One => Xbox One controllers/Xbox One Rapid fire Controllers => Topic started by: coatzavideojuego on September 18, 2022, 07:19:25 PM
-
hi i upload a picture of the values in impedance taken front a good controller i need help to fix the dead controller
https://ibb.co/B387ZwX
-
That might be easy for you to read there, but it is not for anyone else. Impedance measurements are for AC circuits. Resistance measurements are more DC as well as AC. Even more useful would be some Voltage measurements with the USB cable plugged into just the top board. Then start comparing the good one to the bad one and see what is different.
A rough schematic for the 1914 top board is also in the 1914 thread. https://acidmods.com/forum/index.php/topic,44711.0.html
-
no number resistor
3.8 kohms
3.3 kohms
-
You have the bad board there, and a good board, why are you not comparing them? Also, testing values in circuit will not always give an accurate measurement, but if it is way off from a good board then it and everything that connects to it should be checked.
-
i compared and find r24 bad
-
thank you for schematics very helpfull i have a question why when i search a component like Q8 in the schematic i cant find anything
-
Because you are not searching with your eyes. ;) It is not a completed nor a searchable schematic, but Q8 is in there. It's probably a FET versus a Transistor like I have it in there.