Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
once the protype is done try and take one or two of those triggers and put them on the controller
there is a potentiometer in the trigger, but it can be done with thos micro switches as digital I believe. On the top side to the controller there are 3 solder points where the potentiometer connects to the board. One side of your switch needs to be on the middle pin, the other will go on either the above or below joint from the middle, depending on what version board you use. Let me know if you need more help on this