Author Topic: Psp Leds Using Wifi Switch  (Read 1023 times)

Offline Skateandestroy

  • Chief squatting Hard
  • *
  • Posts: 17
  • Post quality +0/-0
Psp Leds Using Wifi Switch
« on: February 27, 2009, 04:20:36 PM »
Ok i have a question i have a spare broken psp motherboard and was wondering if i could steal  the wifi switch from the other psp for leds in  my good psp and i was wondering if someone had a diagram becasue i want to use it to control my leds

Offline rgarjr

  • Ω Allumnist Ω
  • *
  • Posts: 131
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Psp Leds Using Wifi Switch
« Reply #1 on: February 27, 2009, 08:00:27 PM »
It would be pretty much the same as if you were doing it with the WIFI switch.  One leg will have constant ground the other will go to your LM386 chip and/or leds negative inputs if you're using that. 

Offline crazyl69

  • Who Farted ???
  • *
  • Posts: 234
  • Post quality +0/-0
Re: Psp Leds Using Wifi Switch
« Reply #2 on: February 27, 2009, 10:43:33 PM »
    Is the wifi switch broken on your good psp that you need to use it from the broken mobo? If your good psp still has a good wifi switch, you can still use the wifi switch to operate the leds on your good psp. Looking at the wifi switch, you will see three prongs solder to the mobo. You would have to bridge the two closest prongs together and the third one, is where you'll be connecting the (-) wire to the led, on and off function.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal