[PSP Phat] Comprehensive PSP Power Switch Board Pinout Pictures by Alien_X

[Tri-edge]

Thank you to Blizzrad for most of the top half of the pinout, and the original unedited high res pictures of powerboards.
I have part numbers of connectors, so if you are desperate for them then post.


Here is the Top side of the powerboard (if i have anything wrong then please tell me).



Here is the bottom:



I hope you enjoy these, since i spent a good couple of hours on these pictures!

By Alien_X

[Tri-edge]

it's in the title

[Tri-edge]

no problem

[tapdisbong]

hey, how would i solder wires to connect leds from the power board? do i just put dem in the hole and solder it to the ground spot? and where do i solder the other part of the wire ?

[Jumbo]

hey, how would i solder wires to connect leds from the power board? do i just put dem in the hole and solder it to the ground spot? and where do i solder the other part of the wire ?

http://img265.imageshack.us/img265/9026/powertoppj9.jpg

[tapdisbong]

http://img265.imageshack.us/img265/9026/powertoppj9.jpg

do i have to solder them in the holes, or can i solder them straight on the board ?  thanks

[|phoenix|0]

http://www1.minpic.de/bild_anzeigen.php?id=32926&key=54223151&ende


I got 5.5volt and not 3.6.. is it possible?!

i have a ta-086 board

and my powerboard says sw-480


i just wanted to put in leds in my psp and bought 10ohms resitors, like explained in tuts. but 10ohms are not enough for 5.5v... happens

[Jumbo]

Dont think that its possible because ive had a ta-086 and did this mod same way and it was fine..

[Alien_X]

Was the power led turning on also?
Because the actual power point is 5v, but when the psp indicator led is leeching off it, then you only have 3.6v to play with.

[Darkzero]

http://img265.imageshack.us/img265/9026/powertoppj9.jpg

What if you're soldering multiple LED's with multiple wires.. I mean like, 8-12 LED lights around the entire PSP.

[ColdSoldier]

I hope you enjoy these, since i spent a good couple of hours on these pictures!

By Alien_X

Oh hell yes, much apreiciateed, great peice of research, this will be pricelesss to me.

[Ramon-DC]

anyone knows how to wire a microswitch to use as power switch??