« previous next »
Pages: [1]   Go Down

Author Topic: rol help  (Read 909 times)

Offline buickgnx

  • gba modder
  • Granny Spanker
  • *
  • Posts: 451
  • Post quality +0/-0
  • Gender: Male
    • www.MactasticMendezisawesome.com
rol help
« on: August 16, 2009, 08:47:15 AM »
ok so i was switching all the leds to blue. i got the 3rd and 4th working then when i was testing the middle smd(i put in blue yesterday) wouldnt turn on so i tried to fix it with it out side the box and acidently bridged the 3 outpuit's for the smal chip next to the switch, the 6 pin 1 and now when i put the board in the brick led turns red. any help? did i fry the board or the box?
Logged


PsychoticWolf , MactasticMendez and Skullmaster, mike and 802Chives (and all the others:) are the Best Admins On ACIDMODS

Offline scott

  • U.S. Army
  • Registered BST
  • Who Farted ???
  • *
  • Posts: 208
  • Post quality +0/-0
  • Gender: Male
Re: rol help
« Reply #1 on: August 16, 2009, 09:00:57 AM »
So, Unbridge them.

Grab a solder wick or a desoldering iron and fix that bridge, should solve your problems.
Logged

Offline buickgnx

  • gba modder
  • Granny Spanker
  • *
  • Posts: 451
  • Post quality +0/-0
  • Gender: Male
    • www.MactasticMendezisawesome.com
Re: rol help
« Reply #2 on: August 16, 2009, 09:23:45 AM »
nvm got it working
« Last Edit: August 16, 2009, 11:07:11 AM by buickgnx »
Logged


PsychoticWolf , MactasticMendez and Skullmaster, mike and 802Chives (and all the others:) are the Best Admins On ACIDMODS
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal