Author Topic: Brighter Irda (infra red leds for data transfer)  (Read 876 times)

Offline Peewee2000

  • Chief squatting Hard
  • *
  • Posts: 16
  • Post quality +0/-0
Brighter Irda (infra red leds for data transfer)
« on: December 02, 2009, 04:50:52 PM »
I was wonderin if anyone had the pinout of the infra red transmitter and knows a way to boost the power of the signal or what kind of leds i should use like 3mm or 0603 if i were to do this, also what wavelength should they be (i took out my umd drive so i have plenty of room). I ask this because id like to be able to turn on tvs from more than just a few feet away from them. And i do have a night vision scope so i can see how bright they are myself.
« Last Edit: December 02, 2009, 05:27:34 PM by Peewee2000 »

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: Brighter Irda (infra red leds for data transfer)
« Reply #1 on: December 02, 2009, 05:04:37 PM »
ir must have line of sight. thats why they are low voltage and dinsity like that. havent seen that pinout though you can see the IR lights in a camera lense

Offline Peewee2000

  • Chief squatting Hard
  • *
  • Posts: 16
  • Post quality +0/-0
Re: Brighter Irda (infra red leds for data transfer)
« Reply #2 on: December 02, 2009, 05:31:25 PM »
would a lm386 chip be able to boost the voltage without very much distortion?

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal