« previous next »
Pages: [1]   Go Down

Author Topic: headset jack soldering ponts..  (Read 827 times)

Offline atomicareprise

  • Registered BST
  • Acid Modder
  • *
  • Posts: 595
  • Post quality +2/-0
  • Gender: Male
  • FILIPINO SINCE BIRTH
headset jack soldering ponts..
« on: December 19, 2009, 10:57:07 PM »

i want to do sound mod using this amp...

i've seen some tut on am but i'm confused where to solder on the back of the wifi board...

all i know is that this runs on 3.6v...other than that i have no clue at all...

i just need some reference where to solder on the wifi board...thanks..


Post Merge: December 20, 2009, 03:59:58 AM
« Last Edit: December 20, 2009, 04:00:00 AM by atomicareprise »
Logged
viperfan91 (phat), thaq93 (psp phat parts)
pinoyballa  (2 phats ), tri-edge (slim)
Awilliams357- to be shipped

Offline SmaRkieS

  • Fart Sniffer
  • *
  • Posts: 45
  • Post quality +0/-0
  • Gender: Male
  • Made in The Philippines
Re: headset jack soldering ponts..
« Reply #1 on: December 20, 2009, 08:07:32 PM »
i will number that from top to bottom 1-2-3-4

pin 1 and 2 is the negative, if you insert a jack the 1 and 2 will disconnect and it will play the music to the headphone.

if you remove the jack the pin 1 and 2 is connected the sound will play to the psp.

pic 3 and 4 is the left and right.
 
« Last Edit: December 20, 2009, 08:08:29 PM by SmaRkieS »
Logged

Offline atomicareprise

  • Registered BST
  • Acid Modder
  • *
  • Posts: 595
  • Post quality +2/-0
  • Gender: Male
  • FILIPINO SINCE BIRTH
Re: headset jack soldering ponts..
« Reply #2 on: December 20, 2009, 09:01:57 PM »
thanks kabayan..
Logged
viperfan91 (phat), thaq93 (psp phat parts)
pinoyballa  (2 phats ), tri-edge (slim)
Awilliams357- to be shipped
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal