Author Topic: Q:hardmodding the homebar ribbon  (Read 1115 times)

Offline TeaBubblez

  • ~BubbleTea~
  • Ω Allumnist Ω
  • *
  • Posts: 131
  • Post quality +0/-0
  • Gender: Male
Q:hardmodding the homebar ribbon
« on: April 10, 2010, 12:56:49 PM »
does anyone know how to hardmod the homebar ribbon? i know the points to hardmod to on the mobo. but im not sure how to solder the wires onto the ribbon.

Thanks

Offline tooandrew

  • Motor Mouth
  • *
  • Posts: 86
  • Post quality +2/-0
  • Acidmods User
Re: Q:hardmodding the homebar ribbon
« Reply #1 on: April 10, 2010, 01:30:02 PM »
assuming the clip is broken off (why else would you want to wire it?) just put the ribbon where it would be in the clip and like tape it on there, or use hot glue. make sure it's on there properly by turning on the psp with it attached, test it, and if it works glue it in that position. wires will break and its hard to solder to a point that small

Offline TeaBubblez

  • ~BubbleTea~
  • Ω Allumnist Ω
  • *
  • Posts: 131
  • Post quality +0/-0
  • Gender: Male
Re: Q:hardmodding the homebar ribbon
« Reply #2 on: April 10, 2010, 01:34:12 PM »
i never said the wire were broken nor the clip was broken. There is something wrong with the zif connector. That is why i want to hardwire it.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal