« previous next »
Pages: [1]   Go Down

Author Topic: Melted Sync button Replaceable?  (Read 1600 times)

Offline Suprmacdaddy

  • Guppy
  • *
  • Posts: 5
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Melted Sync button Replaceable?
« on: January 07, 2011, 04:37:55 PM »
So i sold 2 rapid fire controllers on craigslist for $100 and a halo reach controller and when i opened the reach controller up at home he had melted the sync button from a fail install of intensafire and i wanted to know if anyone knows if i can just replace it? it is just a tact switch right? and i have an extra board for parts but if anything ill just put a new board in the halo reach shell
Logged

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: Melted Sync button Replaceable?
« Reply #1 on: January 07, 2011, 05:35:22 PM »
it is just a tact switch, replace it. use a solder sucker or braid to remove the solder. make sure not to tear the pads.

« Last Edit: January 07, 2011, 05:36:12 PM by modded matt »
Logged

Offline crazy-modder

  • Research & Development
  • Acid Modder
  • *
  • Posts: 854
  • Post quality +34/-2
  • Gender: Male
Re: Melted Sync button Replaceable?
« Reply #2 on: January 07, 2011, 05:39:19 PM »
The best way to get a sync button off is floating it. Then clean the solder points with desolder braid and replace it with a new sync button.
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal