Hello RDC, everyone
this post to say i succes my solder and ..... it works !!!
BUT ... it's my first micro solder. I apologize if sombody get affraid about only 4 points very huggly
i'm shure i could do better but when i test and saw the light blinking red/orange i waaaaaaaaaas soooooooooooooooooooooooooooooooooo happy so i decide to touch nothing else.
i met some problem , in fact , the LED started about disintegrate on corner and the front protector light move a little.
My iron was at 365 degree celcius , under , my tin move nothing but i know what to do to try next if i brake it again
nothing was possible without your help, i already say it but thank you to help other people