there is a problem with your resistor selection....
if you wire 2 LED's parallel to eachother....
and you are pumping 3.0 volts to them (recomended for the ones your getting off of ebay)
if you go to ledcalc.com....
punch in your selection..
it comes up with 56ohm resistor (if you use multiple resistors.... i would make it to be around 48 ohms... this is simple to do if you have MULTIPLE resistors...
i use SMD resistors... so for me the space would be small still
just dbl check... if you pump too much juice into the led's they will burn out faster... or instantly....
as a note.... i used a 47ohm resistor in this psp...