« previous next »
Pages: [1]   Go Down

Author Topic: Easy LM386N questions  (Read 994 times)

Offline DLoc

  • ½ Pint
  • *
  • Posts: 38
  • Post quality +0/-0
Easy LM386N questions
« on: March 07, 2009, 06:36:33 PM »
Ok, so I'm working on the sound reactive mod of LOrdNico's. I'm currently waiting for a clear housing to come in the mail, and I was thinking that the black electric tape was a bit of an eyesore. So I was thinking about hot glue, It's clear, and will allow me to see the components. Can I cover the LM386n and resistors in hot glue without side affects? Is hot glue is non-conductive? Will I risk overheating the LM386 when it's powered on? Any advice is greatly appreciated.
Logged

Offline bustinthejustin

  • Registered BST
  • E = MC² Mad Scientist
  • *
  • Posts: 2326
  • Post quality +1/-0
  • Gender: Male
Re: Easy LM386N questions
« Reply #1 on: March 07, 2009, 06:42:51 PM »
hot glue should work. It's non-conductive and I don't think it'll affect heat by much. Although if the lm386 get's too hot, the glue will melt... You can always just not cover it. I mean, as long as you isolate it from anything conductive (like maybe cover the mobo near the lm386 with electrical tape) and secure it, it shouldn't short itself out.
Logged

Sig by Kenshinffx - Thanks!

Offline Jumbo

  • Dr. Mod
  • BST BAN
  • Around the block
  • *
  • Posts: 2399
  • Post quality +0/-3
Re: Easy LM386N questions
« Reply #2 on: March 07, 2009, 06:55:57 PM »
Hot Glue will be fine :D Its also not that clear you can clearly see it ;)
Logged

Offline DLoc

  • ½ Pint
  • *
  • Posts: 38
  • Post quality +0/-0
Re: Easy LM386N questions
« Reply #3 on: March 07, 2009, 07:00:32 PM »
cool thanks. Maybe I'll see if I can get away with just tape then glue on the memory stick holder, and the top exposed.
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal