Stuff used XSPC Xbox 360 CPU/GPU Low profile Water block
XSPC X2O 450water cooling Pump with Acrylic Reservoir
3/8 tubes
Thermatake 120mm fan with radiator
Various barbs
Ok to start off this is not a cheap mod.
hees my stock sexy xbox that i revived from a red ring
and then changed it to blue
stock insides
removing heatsinks
soldered uv leds
ok so now were geting somewhere. On the underside of the motherboard, near where you plug the power in, you should be greeted with this delightful array of solder joints. Most of the parts in a watercooling system rely on a molex connector which has
12V.
ground.
ground.
5V . in this picture you can see how i wired mine up
then simply solder these 4 wires into a molex connector.
Ok back to the heatsinks, after you've taken them out scrape and clean the old thermal paste off
with a nice cloth and rubbing alcohol
when its alll ooober shiny add a pea sized drop of artic5 silver paste and gently coat the chips with it, to make a nice thin layer. After that bolt on the water block
. Oh damn i forgot to mention i dremeled a hole out for the tubes
cut off the fins off the back, standard. draw a nice circle and cut it out with a dremel for the fan
do a nice paint job and dont forget to do the hard drive like i did
WHOA what a spectacular drawing
with matching controller
[
alright its done officialy 100% working
if anyone wants to purchase it be my guest, with controller and power cable, even throw in some batteries. Thanks for looking, your comments and opinions are highly valued to oneself so please fear not
