Rapid Fire Method (No Chip)

[ifrgtmyname]

fantastic you lot, just successfully modded 

does anyone else notice this mod does not work when the controller is charging?

thanks again, will post vid soon...

[Bullet Pulse]

Hey, im a noob. Can you give me the links for the radioshack parts I will need?
I have a good soldering gun, wire, flux braid, and solder.
And im picking up a torx t8 security bit this evening.   

I really dont want to up my only controller, so let me know how I can avoid that.

[PspKicks316]

Hey, im a noob. Can you give me the links for the radioshack parts I will need?
I have a good soldering gun, wire, flux braid, and solder.

You don't need anything else except a button, and that's based on personal preference.

[bluedog]

SO you have to solder it to the positive of the the SMD light 1 on the controller? Whatif the controller is controller 2?

[Bullet Pulse]

Can you link me to a button please.
And how do you put it on the bottom of the controller?

[PspKicks316]

SO you have to solder it to the positive of the the SMD light 1 on the controller? Whatif the controller is controller 2?

If you read the thread...
You put solder the 1 wire to the GND of the led. If you're player 1, it goes to the player 1 led. If you're player 2, it goes to the player 2 led, etc. Hope this helps.

Can you link me to a button please.
And how do you put it on the bottom of the controller?

Give me a sec and I'll link you to a few buttons there.
To put it on the bottom of the controller, drill a hole and, well, glue it there..

[Bullet Pulse]

Thank you very much

[Whazup]

Will this work for all series controllers? , Great post!

[KingMike_OS]

This Mod dosen't work on new style controller . as i tested it right now .

so as of now old style controller only i'm working on the new style i will post my result

[PspKicks316]

Ok, here's some buttons I pulled up. You can use ANY button you want. These are just some I pulled up from the website.

Link
Link
Link
Link

Like I said, you can use ANY button you want, you don't need to use any of these, or any from Radioshack for that matter. You just need A button. Hope that helped!

[Bullet Pulse]

How do you know if you have an "old" controller or "new" controller?

[Xboxexpert]

Listen up.  I'm Xboxexpert and I run www.thexboxexpert.com which sells professionally modified Rapid Fire Controllers.   I was ecstatic to see this post until I actually tried it.  My results are in the YouTube video below.  I've also tried it on a NEW Style controller with the same results....IT DOESN'T WORK.


http://www.youtube.com/watch?v=Yj-3ptc6XYo

[PspKicks316]

Youuuuuu :censored:ed up. Regardless of whether it would rapid fire or not, it still connects the gnd and trigger signal. Either way it would shoot. You screwed up, so stop shooting it down and calling it a fake when you don't know what you're doing.

[Xboxexpert]

Your kidding right?  Its connecting to a SOLID ground not a pulsing ground.  Yes, your correct in one point, the new style controllers will fire ONE SHOT if this was wired up.  It will not fire rapid pulsed shots.  To tell me I don't know what I'm talking about when I clearly just showed your administrator up is absurd.  Check your facts buster.

If this was the case then in theory the GROUND for the complete controller would be pulsed.  Meaning all that is connected to the "ground" of the controller would rapid fire.

[PspKicks316]

Listen :censored:head even on an old controller it would still work, STFU and get outta here.


On a lighter note, congrats Mike, it made the front page of Xbox-Scene. http://xbox-scene.com/

[Xboxexpert]

Listen :censored:head even on an old controller it would still work, STFU and get outta here.


On a lighter note, congrats Mike, it made the front page of Xbox-Scene. http://xbox-scene.com/

I'd like for you to stop calling me out on being wrong and actually try this before you tarnish your name in public.

[ifrgtmyname]

Your kidding right?  Its connecting to a SOLID ground not a pulsing ground.  Yes, your correct in one point, the new style controllers will fire ONE SHOT if this was wired up.  It will not fire rapid pulsed shots.  To tell me I don't know what I'm talking about when I clearly just showed your administrator up is absurd.  Check your facts buster.

If this was the case then in theory the GROUND for the complete controller would be pulsed.  Meaning all that is connected to the "ground" of the controller would rapid fire.

if it were a non pulsed ground surely one shot would still be fired?

on another note, my favourite switch is this one:
http://cgi.ebay.co.uk/Standard-Push-to-Make-Switch-Momentary-Action-RED_W0QQitemZ310063661787QQihZ021QQcategoryZ58169QQcmdZViewItemQQ_trksidZp1742.m153.l1262

its big and red but does not bury too deeply

[PspKicks316]

My names "tarnished" enough. I'd like you to stop :censored:ing because you screwed up.

if it were a non pulsed ground surely one shot would still be fired?

Yes, EITHER WAY, 1 shot would still be fired.

[Xboxexpert]

Your are correct on the NEW controllers ONE shot is fired. 

[ifrgtmyname]

Your are correct on the NEW controllers ONE shot is fired. 

not on your video

[PspKicks316]

Your are correct on the NEW controllers ONE shot is fired. 

I am so sick of you. YES it will fire. Finally you agree on something, huh? In YOUR VIDEO nothing fired. YOU SCREWED UP. STOP :censored:ing saying it's fake because YOU screwed up. DON'T even try to claim you have an old controller either, on the old one, EITHER WAY, SOMETHING FIRES.

[Xboxexpert]

not on your video

My video was the old style controller.  On the Video they use Video 1 is a Old Style yet Video 2 is an New Style?!?!

[PspKicks316]

You're just digging yourself a deeper hole. You can't get out as-is, too.

[Nemesis]

the fact the you are owner of that site in which creates rapid fire controllers for customers using i would imagine a PIC chip, and the way in which you spoke within the video,the air quotes at around 46 seconds into the video just demonstrates an impression that you are out to accuse it is fake, in which we all knew in time it would come:

we will wait here patiently for the accusations to fly 

[KingMike_OS]

you want a video with out cutting i give you one.

and i never say it works on all models.

[PspKicks316]

It's good to know people have my back on this one. Xboxphailer, you're wrong

[Xboxexpert]

You're just digging yourself a deeper hole. You can't get out as-is, too.

Let me worry about my status.  This is what I just did RIGHT NOW...Connected a wire to the Player 1 LED (OLD STYLE CONTROLLER) and just tapped the wire to the Middle Trigger pont and it did nothing.  Also on a NEW STYLE CONTROLLER it fires one shot NOT RAPID

[ifrgtmyname]

My video was the old style controller.  On the Video they use Video 1 is a New Style yet Video 2 is an Old Style?!?!

ah ok i re-read your post. I have this mod working right now with an old controller, recheck your wiring, you might have accidentally cold soldered somewhere and please don't use sarcasm like in the video, kingmike has no reason to lie as he makes no profit

[Xboxexpert]

you want a video with out cutting i give you one.

and i never say it works on all models.

All models would be New Style and Old Style...In your videos your using BOTH new and old style controllers,  unless I'm wrong the OLD Stlyes have the little nub on the pad's...the NEW Styles dont have the nub its a full circle for the pads.  I'm just saying I have a NEW and OLD style on my desk in front of me wired up and I get no results even close to rapid fire.

[PspKicks316]

You do realize it's you against a whole site, right? And you're accusing an ADMIN of being a liar, correct? And let me get this straight. You run a site and you make rapid fire controllers for people, right? It FIGURES. Just stfu before you really piss off an admin.

All models would be New Style and Old Style...Thats basically it.

You're forgetting about WIRED controllers too. He's right just give it UP.