TUT:
1. buy razor X from coolmods
2. replace the original circuit board of the analog stick with the razor X circuit board and replace the contacts of the circuit board with a small washer(the size of the circle in the middle of the RAzor X).
3.solder to the points on the X[]O/\ board (power board) with five wires, as show in this pic:
4. solder the wires attached to the Razor X board like so:
X button solder goes to the bottom.
[] goes to the left
O goes to the right
/\ goes to the top
GND goes to the circle in the middle.
5. dremel away anything in the way, and on the faceplate
6. install, and if neccessary, glue to faceplate