« previous next »
Pages: [1]   Go Down

Author Topic: Razor x easier to solder?  (Read 1644 times)

Offline Sanctus

  • Acid Modder
  • *
  • Posts: 606
  • Post quality +1/-0
  • Gender: Male
Razor x easier to solder?
« on: July 09, 2008, 04:41:05 PM »
Just had an idea today. Because its prety hard to solder to those pins on the mobo for the razor x, my idea is tat you could get a piece of plastic, get the wires from the razor and lightly melt them to the plastic farish apart. then get a conductive pen and make a line from each pin to the correct wire on the plastic. duno if this is easier cause iv never actually done the razor x but just an idea :dntknw:
Logged

Offline ApheX

  • Club AM VIP
  • Millennium Poster
  • *
  • Posts: 1094
  • Post quality +1/-0
  • Gender: Male
  • PSP And PSP Slim Case/Hardware Modder
    • ApheX MoDs
Re: Razor x easier to solder?
« Reply #1 on: July 09, 2008, 05:16:02 PM »
to be honest i think it would be easier to solder. yes the solder points on the razor are small but with a bit of practise it's fine. nice idea tho.  :tup:
Logged

Offline Sanctus

  • Acid Modder
  • *
  • Posts: 606
  • Post quality +1/-0
  • Gender: Male
Re: Razor x easier to solder?
« Reply #2 on: July 09, 2008, 06:58:35 PM »
nono not on the razor i mean when you solder to the pins on the mobo they are extremely small so this would be easier i would assume. I can solder the razor x pretty easily but i haven't tried to solder to the pins yet so idk
Logged

Offline l0rdnic0

  • 2%
  • Acidmods Alumni
  • E = MC² Mad Scientist
  • *
  • Posts: 1836
  • Post quality +8/-0
  • Gender: Male
  • TeamCYBER

Re: Razor x easier to solder?
« Reply #3 on: July 11, 2008, 04:27:37 PM »
It takes a little time but it can be done
Logged


L0rdNiC0 Pioneering Mods on the PSP Slim :taunt:
Sound Mod, Button LED Mod, Security Mod, Dual NUB, Mode Select Switch + More

Offline ReZiN_420

  • Chief squatting Hard
  • *
  • Posts: 17
  • Post quality +0/-0
  • Gender: Male
  • Moding is not a hobby, it's a habit
Re: Razor x easier to solder?
« Reply #4 on: July 11, 2008, 04:29:33 PM »
Well Sanctus i would just use about the same technique you used to solder to the razor x, I plan on soldering to the pins today so i'll let you know how it goes.
Logged

Offline Sanctus

  • Acid Modder
  • *
  • Posts: 606
  • Post quality +1/-0
  • Gender: Male
Re: Razor x easier to solder?
« Reply #5 on: July 11, 2008, 06:08:42 PM »
Alright thanks alot man and it'd be awesome if you took some pics  :tup:
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal