Need slight help with sleeper installation.

[Bullet Pulse]

Here The Digram Sleeper "Old Style Controller Only" Power Saver :



On the yellow line it shows two wires but as the same color (yellow).
Do I wire it like the diagram (2 soldering points) , or only solder to one of those points?

[wilson08]

You get to choose where you want to solder the wire, out of the two yellow wires shown!

[Bullet Pulse]

I think you are wrong sir.
I soldered both points to wires, and then soldered both wires to the chip.
And it works fine.

Im glad to have the updated chip!
Great job on the chip Mike!
It's working great first try :]

[Bullet Pulse]

Does anyone know for sure what to do with the yellow line?

[KingMike_OS]

OK Just Use one Which ever is easy for you .. Some people where having problem with the middle pin Sync Switch
So i.m Giving you a 2nd Location Pick one Which ever you like they both the same point. 

[Bullet Pulse]

OK Just Use one Which ever is easy for you .. Some people where having problem with the middle pin Sync Switch
So i.m Giving you a 2nd Location Pick one Which ever you like they both the same point. 

I called you earlier Mike, you dont need to call me back now.
Sorry bout that :]

On my controller I soldered wires to both points, and then I connected the two wires to the chip,
so I am using both of them xD

Soldering onto the middle pin Sync Switch was actually not too hard.

P.S. what is rumble mode awareness?

[KyleP]

chose which is best for you i would do the one that connects to the wireless connect button

[wilson08]

OK Just Use one Which ever is easy for you .. Some people where having problem with the middle pin Sync Switch
So i.m Giving you a 2nd Location Pick one Which ever you like they both the same point. 

So i am not wrong !

[KyleP]

right your not wrong well if you did it by now did it work