CLean drill holes

[pmcgrorey]

how do you guys get such clean holes when driling mine leaves a huge lip

[kink192]

drill from both sides. take needle nose pliers and carefully tear it off, or burn/melt it.

[pmcgrorey]

thanks

[SYSTEM aka (Cyberpyrot)]

I use a powerful laser I call "Preperation H"

[SN!P3R]

I use a powerful laser I call "Preperation H"

lol.

i use a dremel drill half way, flip over, drill from the other side.

[gameroms]

its called "skill", lol.

i use a hobby knife to trim if it has a lip.

[Winterz117]

i just use my dremel and drill it from teh outside in and clean it with a razor

[Alien_X]

Hobby knife, dremel, drill press.

[pmcgrorey]

drill from both sides. take needle nose pliers and carefully tear it off, or burn/melt it.

thanks mine came out perfect

[Containm3nt]

De Walt Cordless, stepping up the size 2 or 3 times till I get the right size hole, then the X-acto knife. Also start on the outside going in and clean the inside edge.

[802Chives]

De Walt Cordless, stepping up the size 2 or 3 times till I get the right size hole, then the X-acto knife. Also start on the outside going in and clean the inside edge.

Pre-drill with smaller bit first from inside, then use the required bit from outside. Buff up with Xacto Knife. Like ^he^ said

[Containm3nt]

To keep the bit from walking, I take something with a very fine hard point and make a small divot or mark where i want the bit to drill through, then begin with the smaller bit. I learned that little lesson the hard way...

[Winterz117]

yeah me to haha

[KingMike_OS]

I don't even use a drill ..

I use a high Power Green Lazer 

[Alien_X]

I don't even use a drill ..

I use a high Power Green Lazer 

If you are joking, then 

Otherwise, awesome!

[bill16504]

Wow. A bunch of you guys do it the hard way. I drill my holes to size on a drill press then clean up the lip and put a slight chamfer on by gently twisting a phillips head screwdriver in the hole. Works beautiful.

[Winterz117]

oh never thought of putting a chamfer on thats a great idea!