[Tutorial] Official Sony Headset RoL and power LED swap

[blackburn]

Remove the 2 screws at the top by the speaker (Torx) and get a flathead screw driver and gently pry around the edges (there are small clips holding the rest together) untill its starts to pop apart like this.



After that, gently pry from the back and towards the USB port at the top (be careful not to rip off the mic at the opposite end, its held there by some thin/cheap wire) untill it comes apart as show below. The LEDs are marked + and - on the PCB, and in the pic, it gives you the location of the 2 LEDs that need to be swapped.



And here it your final result!!!

[SYSTEM aka (Cyberpyrot)]

awsome

[tapdisbong]

nice i was thinking about doing this before lol.

[GBlaster]

Looks nice!

[blackburn]

yea, everything else for my ps3 is blue, so i went ahead and put this finishing touch on my collection lol 

and thanks guys!