burnmeup 2 not working on matrix controller

[xSLICKVICx]

Hi i installed hazers code exactly as the diagram showed but the rapid fire is always on and it dont change modes any reason why?

[Hazer]

One of two things:

1: did you wire the chip with the legs facing down so the notch is facing up as in the diagram?

2: If so, then replace the resistors going to the triggers with 1000 Ohm resistors and see if that works.

[treemty]

I already helped him, he used wrong resistors

[Modded Matt]

I probably should have take the rapid on buttons out of the tut. I can see now people wiring it without resistors, and without the push buttons and getting an auto fire problem. I was kindof expecting this. LOL