« previous next »
Pages: [1]   Go Down

Author Topic: How do you keep joints unexposed?  (Read 1762 times)

Offline jak33

  • Chief squatting Hard
  • *
  • Posts: 20
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
How do you keep joints unexposed?
« on: July 25, 2009, 03:56:03 PM »
Inside my PSP, i had the joints covered with electrical tape when i only had the LEDs and such for a trigger mod. Just recently, I did the RoL mod, and then put blue ones in addition to the green ones for a total of 6 new LEDs. the electrical tape doesn't work here anymore, as there are way too many joints now. how do you guys keep joints unexposed inside you PSP? (just for clarification, i mean wire to wire joints)
Logged

Offline injungleist

  • Club AM VIP
  • Who Farted ???
  • *
  • Posts: 200
  • Post quality +0/-0
  • Gender: Male
  • mod your face off.
Re: How do you keep joints unexposed?
« Reply #1 on: July 25, 2009, 05:06:15 PM »
you can always run a small jumper then put your connects to the jumper, so only one set of wires is going to the speakers.
Logged
thx gamerdude767
trades w/ blazinkaos
purchases from sniper (fast shipping)

Offline jak33

  • Chief squatting Hard
  • *
  • Posts: 20
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: How do you keep joints unexposed?
« Reply #2 on: July 25, 2009, 06:18:00 PM »
no, I have a lot of wires connecting to each other with solder joints, but i don't want them exposed to touch other joints and short out...
Logged

Offline 802Chives

  • Sargeant at Arms
  • Acidmods Alumni
  • Millennium Poster
  • *
  • Posts: 1304
  • Post quality +10/-0
  • Gender: Male
Re: How do you keep joints unexposed?
« Reply #3 on: July 26, 2009, 08:21:06 AM »
hot glue will protect ur solder job from shorting.

In the industry it would be referred to as "conformal coating".
Logged

Offline Modded Matt

  • Site Owner
  • Administrator
  • Around the block
  • *
  • Posts: 4649
  • Post quality +65/-3
  • Gender: Male
Re: How do you keep joints unexposed?
« Reply #4 on: July 26, 2009, 12:36:41 PM »
heat shrink tubing
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal