Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
I just ordered all the parts for this tonight.. have a couple xenons laying around.i'm hoping that someone will be able to help me through this... *cough, cough, crazy*
this tut is very helpful, i had some problems, but once i did it, it went very easy, I have never done this before and after doing it I realized just how simple this tut was, probably the best tutorial I have seen and easiest to use. read carefully and everything will work out great.
Dont forget to add the diode i mentioned in one of my posts above. If you dont you will not get a clean backup of your nand. You will know that you have a clean backup when you make two dumps and open them both in a hexeditor and compare the two files. If they are identical you have a good backup. If not, then dump another one, if none of them match up check your wiring and dump again.
Yeah i just got done jtagging a xenon and i didnt need a diode.... Just follow this tutorial
Dude ive done about 30 jtags and never used a diode on a xenon....I use total commander to compare the nand dumps and have identical dumps every time. As long as you have 2 good matching dumps then your good.
Im not trying to give you or anything Anonamous lol. I have heard of cases where people do use diodes on xenons but i have used this tutorial every time i do xenons and never had any problems. I have had bad nand dumps only because my wiring didnt have a good connection so i just desoldered it all and re soldered then got 2 good matching dumps
GUYS! The reason for the diode has to do with noise switching on the parallel port. The reason it is required or not has to do with each persons parallel port on thier computer. Thats why crazymodder does not need one and Anonomous does.Ive read a tutorial that says to put the diodes in to start, and remove them if the dump is no good.
I wasnt trying to give you either crazy lol. Just trying to help out.Yes lol thank-you. That clears up a lot lol...So nEoVaLoR dump 2 nand dump and check them to see if they are identical, if they are not, dump a third one, if none of them are identical then put in the diode (put it on the motherboard, not on the lpt cable) and dump two more and then they should match.
Neo, i can sell you a complete nand dump kit. $10 and it will have everything you need.
i was wondering does this work with a zephyr motherboard? Can i remove the resister and wire from the xbox after im done jtagging it?