« previous next »
Pages: [1]   Go Down

Author Topic: 1708 only LT vibrates when pressed after LED mod  (Read 1067 times)

Offline geo266

  • Guppy
  • *
  • Posts: 3
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
1708 only LT vibrates when pressed after LED mod
« on: June 22, 2021, 11:00:19 AM »
Hi everyone

Recently did a custom LED buttons mod on an S controller and made sure they light up correctly with volt meter, but when I put it back together it didn't light up (it used to function normally).

I tested the capacitors for short and they seemed fine, the wires I soldered the LED buttons are TP9 for power and TP7 for ground.

Has this issue happened to anyone else?
Logged

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2600
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: 1708 only LT vibrates when pressed after LED mod
« Reply #1 on: June 22, 2021, 11:45:27 AM »
No need for cross posting.

TP9 is the 3.3v rail for most of the controller, TP7 is the 3.5v rail for the motors, so no idea why you chose that combination.

Remove everything that you did in there first and test the controller.
Logged
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline geo266

  • Guppy
  • *
  • Posts: 3
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: 1708 only LT vibrates when pressed after LED mod
« Reply #2 on: June 23, 2021, 08:38:43 AM »
I was just looking for a constant power point and a ground so when I saw those I thought it could work lol.

I desoldered these points and its the same issue, just LT vibrates when pressed nothing else lights up

 also tried removing antenna from first PCB, same issue, forgot to mention I also replaced both sticks
« Last Edit: June 23, 2021, 08:46:44 AM by geo266 »
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal