Author Topic: PS5 Dualsense Controller 0.2amp draw while charging  (Read 564 times)

Offline Kadudi88

  • Guppy
  • *
  • Posts: 4
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
PS5 Dualsense Controller 0.2amp draw while charging
« on: September 13, 2023, 05:18:17 PM »
Hi Guys,

I have a PS5 controller (Scuff Reflex) that I have replaced the Type C charging port on due to broken pins. The board is the exactly the same as a V1 Dualsense controller

However the controller is only charging at 0.2amps. I have seen online that it should be charging at approximately 1.5amps

Any help would be much appreciated cheers

Offline Eren_Ackerman

  • ♪♪♪ Tone deff ♪♪♪
  • *
  • Posts: 64
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: PS5 Dualsense Controller 0.2amp draw while charging
« Reply #1 on: September 13, 2023, 08:17:08 PM »
I would imagine that when the pins broke/bent, they shorted something inside one of the chips. I have to specify that I haven't tried fixing Dualsense controllers yet, but my assumption would be that the charge IC was affected somehow. Either that or you knocked some other component when you were soldering the Type C connector.

Offline Kadudi88

  • Guppy
  • *
  • Posts: 4
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: PS5 Dualsense Controller 0.2amp draw while charging
« Reply #2 on: September 14, 2023, 02:51:57 AM »
Thanks for the reply. The controller was itself was charging intermittently due to the damaged pins on the board side. Even prior repair it was charging @ 0.2amps if the pins were making a connection to the pads on the board. Does anyone know what the name of the charging/power IC is on the Dualsense controller? Would there be a way to jump a wire to the dock connector on the bottom of the controller

Offline Eren_Ackerman

  • ♪♪♪ Tone deff ♪♪♪
  • *
  • Posts: 64
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: PS5 Dualsense Controller 0.2amp draw while charging
« Reply #3 on: September 14, 2023, 06:44:43 PM »
There are different models of boards. You would have to identify the model or post a picture. Quick tip: using imgur.com it's super easy. You upload a picture, click the three dots and then on "Get share links". Then the "forums" link it is.

The model is written like this:

Offline Kadudi88

  • Guppy
  • *
  • Posts: 4
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: PS5 Dualsense Controller 0.2amp draw while charging
« Reply #4 on: September 16, 2023, 02:28:10 PM »
Yes the Scuff Reflex I have here is a BDM-010 I have a good board here also and checked the USB-C Port Diode reading using a multimeter both reading the same. I suspect the fault is no where near the charging circuit. Here are the readings I have recorded:

Dualsense BDM-010 USB-C Readings
Starting from left to right*

Red Probe on Ground, Black Probe on pins

1:   0.002v (GND)
2:   0.655v
3:   OL
4:   2.09v
5:   0.592v
6:   0.591v
7:   0.592v
8:   0.591v
9:   OL
10: 2.094v
11: 0.651v
12: 0.002v (GND)

Black probe on ground, Red probe on pins

1:   0.002v (GND)
2:   2.3v
3:   OL
4:   2.09v
5:   1.53v
6:   1.523v
7:   1.525v
8:   1.527v
9:   OL
10: 2.094v
11: 2.3v
12: 0.002v (GND)

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal