Author Topic: BDM010 PS Button grounded after analog stick replacement  (Read 703 times)

Offline galaxdy

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
BDM010 PS Button grounded after analog stick replacement
« on: November 07, 2023, 09:34:40 AM »
I bought a used controller that had stopped holding charge according to description - cause appeared to be some water damage after inspection as there was corrosion on the circled areas. Cleaned it up and got it working fine (capacitor fell off on the area marked '1', however controlled functioned fine without it). But after removing the right analog stick, the PS button is now always active and I can't figure out how to fix it. Everything else still works fine. Any idea what it could be?

https://imgur.com/a/W2YvEpr

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: BDM010 PS Button grounded after analog stick replacement
« Reply #1 on: November 07, 2023, 11:17:43 PM »
You're missing the 100k pullup Resistor on the PS line.

Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

Offline galaxdy

  • Guppy
  • *
  • Posts: 2
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: BDM010 PS Button grounded after analog stick replacement
« Reply #2 on: November 11, 2023, 08:34:04 AM »
Amazing thank you!! Added one and the button works as normal now

Offline RDC

  • Administrator
  • Around the block
  • *
  • Posts: 2609
  • Post quality +90/-2
  • Gender: Male
  • The CGnome Project
Re: BDM010 PS Button grounded after analog stick replacement
« Reply #3 on: November 11, 2023, 11:09:48 AM »
Welcome.
Screwing up is one of the best learning tools, so long as the only thing you're not learning is how to screw up.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal