clear case help

[sakobatoneko]

well i searched the forums for some clear case problems i fixed almost everything but i couldnt find 2 answers that i need. #1 how can i make the slide thing to turn on the psp go back to the middle once i turned it on. #2 where on the power board am i supposed to dremel down?

thanks for your help

[4dP]

the powerboard usally does that for you and you don't dremel the powerboard but the piece of plastic near the gears so it does no obstruct it

[sakobatoneko]

i heard that u have to dremel somthing to make the powerboard not lift up by its self.

[psp_nl]

Shouldn't the powerboard just fit?

[4dP]

i think your talking about the plastic that holds the wifi antenna just dremel that in most cases you will never need to dremel a powerboard

[sakobatoneko]

ok, so i just dremel the 3 little stands that hold the antenna. that should fix it right?

[*FuFa]

ok, so i just dremel the 3 little stands that hold the antenna. that should fix it right?

You do know that the Powerboard was laying on those stands... and why should it lift itself anyway, you are pressing it down by pressing a button anyway, I don't see why you would ever do that.

[sakobatoneko]

yes i know that the powerboard sits on top of those 3 stands. When i put the powerboard there it gets stuck to the yellow thing that is attached to the sliding switch. When i turn on the psp the powerboard lifts itself up and then i strougle to turn it off.

[4dP]

use hot glue?

[budgray19]

show some pics
yea
pics will help

plz its best to see it before u take action

[4dP]

hot glue can be taken out easily

[sakobatoneko]

well i manage to fix it some how thanks for all of your help