my charge mod doesn´t work anymore

[Rapten126]

i did the ubs charge mod and at the first time it´s all ok but ca. 1 month later it doesn´t charge.
please help.

thx

[crashman2k7]

Most likely you burnt out your charger's fuse (located top right corner) just fuse it from point to point wid a wire and it should be fine

[Rapten126]

thx i try it out

[Rapten126]

1 more question when i do this than i make a short ?

[crashman2k7]

nope u make a bridge =) fuse are only there to make connections if it blown it can be replaced with almost anything(depending size of amperage) in ur case it not much
i use to fix blown fuses of my house with a nickle:)

[Rapten126]

^^ thx it works fine

[crashman2k7]

np:)

[Rory]

i use to fix blown fuses of my house with a nickle:)

Uh... Replacing a fuse with a nickel is BAD.
Sure it works but its BAD.
Fuses are there to blow if there is a power surge to protect electronic items in your home.
Power surges cause the bit inside to melt and stop the connection.
A nickel won't melt. Thus going straight into all your stuff.
Possibly resulting in dead electronics/home on fire O_O.

Be careful mate :P.