Author Topic: R2 trigger moving on its own  (Read 1377 times)

Offline Nemesis

  • Millennium Poster
  • *
  • Posts: 1186
  • Post quality +0/-0
  • Gender: Male
R2 trigger moving on its own
« on: June 15, 2008, 05:06:08 AM »
well i soldered a wire to the R2 trigger pin on the connector, i de-soldered it and happened to get some solder on the pin next to it, meaning theres solder covering the 2 pins, would this be causing the R2 trigger to be moving/pressing on its own?

thanks

Offline light_matt

  • Motor Mouth
  • *
  • Posts: 95
  • Post quality +0/-0
  • Gender: Male
Re: R2 trigger moving on its own
« Reply #1 on: June 15, 2008, 05:53:57 AM »
Uve soldered R2 and R1 together de-solder them or clean it up, because it wont functions properly, sometimes it can press triangle, circle and X on its own because the ground circuit is joined up to it.

Offline Nemesis

  • Millennium Poster
  • *
  • Posts: 1186
  • Post quality +0/-0
  • Gender: Male
Re: R2 trigger moving on its own
« Reply #2 on: June 15, 2008, 06:04:24 AM »
well i spent ages because all i have is desoldering braid which i cant use properly but i just managed to split the joint completely and now it works perfectly

thanks a bunch

p.s: you have msn? you know a lot about the sixaxis and i have a few questions

Offline light_matt

  • Motor Mouth
  • *
  • Posts: 95
  • Post quality +0/-0
  • Gender: Male
Re: R2 trigger moving on its own
« Reply #3 on: June 15, 2008, 06:20:09 AM »
I PM you.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal