PS2 Controller Help

[Blazinkaos]

Hey guys im planning on making a PS2 Rapid Fire controller and i searched around on the site and found one thing but doesnt really help at all.
https://www.acidmods.com/forum/index.php?topic=8734.0
I searched google seems as there a lot of 360 controllers and PS3 rapid fire controllers but none for the PS2. So if anyone know a TUT that know of that would help what Im looking for.

[Dark_Daniel]

on youtube it shows how with jst paper clips

[PspKicks316]

on youtube it shows how with jst paper clips

There's no way that will work. You need at least a 555timer circuit or something..

[Blazinkaos]

hmm 555timer circuit one that is compatible. I seen ppl use a PS2 controller for the PS3 but but will that work idk.

[kink192]

you can do what i did for my shocker mod, rig a 555 and a relay together.

[Blazinkaos]

you can do what i did for my shocker mod, rig a 555 and a relay together.

ight well were would i get the 555 and do u have a tutorial that i may use

[PspKicks316]

You can get a 555timer at an electronics store like RadioShack

[kink192]

ill draw you up a schematic later for wiring it up. its fairly easy

http://www.eleinmec.com/figures/003_03.gif that should help you a little, where it says device, thats gonna be your relay. anyone else want to jump in and finish this up for me, im kinda tired

[Blazinkaos]

ight thanks pspkick. The diagram helps a little and dnt know all the point on it and is this on the ps2 controller. I dnt where like all the power source connection and all that is on the controller.

[kink192]

lol...the diagram is of the 555 timer ic, for power i recommend leaching from another source and then using a new pushbutton. but further explanation of the diagram. the grey square in the middle represents the ic, the lines with the numbers coming off of the square represent the leads coming off the ic, the smaller rectangles are resistors, the two lines running parallel to one another are capacitors, and the square that says device, thats gonna be your relay, what it doesnt have is a switch coming off of vss, you want to put a switch there, then you want to take the leads coming off of the relay and solder them to the points where the r1 connects to the main board, hope this helps

[Blazinkaos]

yea once i get the 555 it should make a lot more sense but most of what u said helped. It will be more understandable once i get the thing so i will get back to u once i get the timer.

[kink192]

good luck

[Blazinkaos]

yup thanks man

[kink192]

dont know if you still need this or not, but i made you a schematic of what you will need to do


the two leads on the far right are going to get soldered onto the points where R1 is attached to the main board. make sure you add a momentary push button or it will be non stop rapid fire

[Blazinkaos]

thanks for the support kink192. ill ry it and see if it turns out right and the momentary button where can i get this like from a component rather then buying it.

[kink192]

possibly, theyre dirt cheap though so if you cant i dont see if itll be a big deal

[Blazinkaos]

yea i dnt think so either.