Author Topic: Fuse to Fuse Situation  (Read 1146 times)

Offline PSPMAN90

  • Chief squatting Hard
  • *
  • Posts: 16
  • Post quality +0/-0
Fuse to Fuse Situation
« on: August 08, 2008, 10:43:46 AM »
everything works except the Backligth  Flex cable of 4 pins in, cable get messed up when Hooking up, and the pins fell off...

Now it doesn't have pins -_-

But I was thinking if I can solder another cable to the fuse inside the back light   on the left of all 7 leds...

I mean I just need a cable to transfer energy so i can turn on the Light, the FD fuse still works, so no is not the fuse.

Then solder that cable out of the back light fuse to the FD fuse directly or just to the four pin connector where the flex cable used to be?

So any Ideas?

Thanks!
PSPMAN90
« Last Edit: August 08, 2008, 11:39:55 AM by PSPMAN90 »

Offline DubbleDutch

  • BlietZ Modding
  • Millennium Poster
  • *
  • Posts: 1234
  • Post quality +3/-0
  • Gender: Male


Re: Fuse to Fuse Situation
« Reply #1 on: August 08, 2008, 11:20:40 AM »
something like this happend to a customer of mine too.












To all of you crying about lag and kicks, remember… when Jesus died, took him 3 days to respawn. Now THAT is lag.

Offline PSPMAN90

  • Chief squatting Hard
  • *
  • Posts: 16
  • Post quality +0/-0
Re: Fuse to Fuse Situation
« Reply #2 on: August 08, 2008, 11:39:17 AM »
Ok, so I must solder two cables to extend the Flex cable?

The flex cable doesn't have any pins they fell off...

Is just flex cable cut it without 4 pins.

So I must solder two cables on the Flex cable with soldering cable to the backlight port?(where the flex cable goes)

Yes?

Thank you

PSPMAN90
« Last Edit: August 08, 2008, 11:41:21 AM by PSPMAN90 »

Offline DubbleDutch

  • BlietZ Modding
  • Millennium Poster
  • *
  • Posts: 1234
  • Post quality +3/-0
  • Gender: Male


Re: Fuse to Fuse Situation
« Reply #3 on: August 08, 2008, 11:51:53 AM »
you can scrape of some of the protective plastic on the flex cable ;) i did that too after that they came loose because i had to remove the screen.

make sure to put some tape on the connections when you are closing the psp ;)



To all of you crying about lag and kicks, remember… when Jesus died, took him 3 days to respawn. Now THAT is lag.

Offline PSPMAN90

  • Chief squatting Hard
  • *
  • Posts: 16
  • Post quality +0/-0
Re: Fuse to Fuse Situation
« Reply #4 on: August 08, 2008, 12:00:16 PM »
I scrape off the protective plastic of the Flex cable from behind?

I did with a knife, but I think it didn't do anything just curl that part of the cable :(

Can I show you some photos of how does it look?

Please!  :beg:

Thanks
PSPMAN90

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal