Author Topic: razor x question  (Read 2196 times)

Offline longcat1

  • Chief squatting Hard
  • *
  • Posts: 15
  • Post quality +0/-0
razor x question
« on: July 28, 2008, 01:09:17 PM »
ok, i figured out how to assemble the spring nub but is there a way to stick the razorx to the nub because the spring causes the board to pop out. :confused:

Offline 4dP

  • Millennium Poster
  • *
  • Posts: 1426
  • Post quality +0/-0
  • Modder For Hire - AM Donator
    • Modder For Hire website Hire me
Re: razor x question
« Reply #1 on: July 28, 2008, 01:10:47 PM »
balloons rubber bands elastic

PINOY AKO

Offline anthonyta

  • MFH
  • Granny Spanker
  • *
  • Posts: 422
  • Post quality +1/-0
  • Gender: Male
Re: razor x question
« Reply #2 on: July 28, 2008, 01:58:15 PM »
Do you mean in the sense of keeping the casing together , tight with the board?

if so

I find melting the plastic legs onto the razor board, and then hot-glueing together works best, or you could use blue tac

yup

Offline longcat1

  • Chief squatting Hard
  • *
  • Posts: 15
  • Post quality +0/-0
Re: razor x question
« Reply #3 on: July 28, 2008, 02:33:13 PM »
ooooo ok ill try thanks :D

Offline longcat1

  • Chief squatting Hard
  • *
  • Posts: 15
  • Post quality +0/-0
Re: razor x question
« Reply #4 on: August 22, 2008, 10:41:28 PM »
okay, now i have a problem. i went 2 solder the razor board but when i used iron and wire, after it harden, it fell off with the litte pad. so i soldered directly to the dot and it made that fall off. i used flux and i have soldered many things befor but this takes the cake, and my razor board... :cry2:

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal