Sleeper question with pics

[mhawk134]

Mine should be here tomorrow and I just want to make sure I got this down, it should be wired up like this right.



Hawk

[kink192]

yes you have it right, but you need to fix the numbering on the chip it goes like this:

    _____
1-|       |-8
2-|       |-7
3-|       |-6
4-|____|-5

[Bullet Pulse]

Just follow the instructions that were sent to you by KingMikeOS.

[KrInEn]

Can you use the sleeper method install on say a chip I got from eBay?

[KingMike_OS]

Mine should be here tomorrow and I just want to make sure I got this down, it should be wired up like this right.

The powe is in the worng place please use power saver on all installation. or you drain the battary and Damage the chip

[mhawk134]

The powe is in the worng place please use power saver on all installation. or you drain the battary and Damage the chip

Um I just checked and the power is the same as the power saver in this pic.



Ah never I just looked really close and see where the point isn't the one that I thought it was, good looking out mike, i'm goingto change that here in a few minutes, thanks.

Hawk

[wilson08]

hey, i installed my chip today - At first i put mine in the wrong power point... I was trying to figure out why it was'nt working for ages, eventually i burnt the sync button as i thought i wasnt soldering it right. I desoldered everything and then i figured out i had the wrong power point ! - i then installed on my other controller...Works perfect everytime!