Okay now i have searched and searched, But i havent found the answer to my question. The ps2 controller mod i am so stuck well and out a psp but thats okay because i am going to buy another one.
I will ask all the questions in a row please reply back with a row of answers
1 what is suppose to be the reading of resistance on the a2d analog control ps2 side.
a1 =
a2=
a3=
my readings are as follows:
a1=doesnt read until moved left (Multimeter set at 2000k ohm and reading 000 when pressed left)
a2=doesnt read even when i move my joystick around
a3=doesnt read until moved down (Multimeter reading 000 when pressed down)
wiring is like this
+---->1
| A3-------------->to psp analog
+ --------------->Gnd
| |
Gnd a1 a2
| |______________>to psp analog
|
+----------------------->to psp analog
if these are wrong how can i fix them i opened the analog sides and cut the trace in the middle.
2 where do i make the solder connections for the directional pads on this board?( i already made spots i am not sure if its right)
3 where would i make the solder connections for the tri , x , square , circle?
( i already made spots not sure if they are right)
thats about it..