Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
The support and the tut. for the PICKIT2 is well worth the money. But the other info.... Thats good to know.
just a question, is this wired just like the diagram for cod4, or is it different. I edited the hex, wired it up like i did for cod4, but its acting weird. The button doesnt work, but when i press the trigger, its on rapid fire. It should happen when i hit the button, not the trigger. Im only using one button and trigger. Any help would be great, thanks!
Thanks for all this info, Im really excited to get started. I decided to buy my own programmer though. Would this work?Or this?
A friend and I very intrested in doing this also. We are looking at the PICKIT2 Starter and a few 12F683's and maby a 16F84A. I did notice however there are about 6 diffrent types of 12F683's. I need the IP version correct? I am not alone on this project ither my friend is doing the code but I am doing all the wiring and testing. ( the 555 rapidfire just isnt cutting it any more ) We are not looking to make any money on this, its just for fun. Yes we know it would be cheaper to just buy one from the acid mod store and install it, but were is the challenge in that? That being said I would like to know if we are looking at the correct stuff to make this happen. We only have about $100 bucks to make this happen. (Sorry if Im in the wrong thread guys)
Which one? lol. Either? Which one do you think would work best?Or maybe this one?
My 555 timer is alot faster then my sleeper i did, what resistor did you use?
I agree the 555 is adequite to do the job, but when you compare the 555 to a good programed 12f683, its like driving a pento vs a cadilac (some of you young lads may not know what a pento is LOL... but it was a piece of junk, simmilar to a yugo, or a grimlin..LOL now I am really showing my age)
today is 1/22/09 at 12:09pm...I need to pull alot of info so there will be at least two updatesthis is everything you need:start with one of these codes: thanks to hazerhttp://www.microchip.com/forums/attachment.aspx?m=364122 with button on/offhttp://www.microchip.com/forums/attachment.aspx?m=361399 for sleeperpics for sleeper are here http://www.microchip.com/forums/tm.aspx?m=353574&mpage=14this code was for cod4 the asm needs to be modified for cod 5, modify one of the fire rates to read 0x3f for cod 5 then you need to recompile the code, use this free program:http://www.microchip.com/stellent/idcplg?IdcService=SS_GET_PAGE&nodeId=1406&dDocName=en019469&part=SW007002then build this programmerhttps://www.acidmods.com/forum/index.php?topic=22283.0 and use this free program to write the info to the 12f683 i/p chip: http://www.winpic800.com/index.php?option=com_content&task=blogcategory&id=19&Itemid=88&lang=en order the 4 free samples of the 12f683 i/p chip from microchip directtotal cost around $30.00, including programer with enough parts to mod 4 controllers.thats it everything you need is listed post complete