Poll

How do i light up back ring?

use plastic piece acros bak
0 (0%)
fil blank w/umd cover
1 (100%)

Total Members Voted: 1

Author Topic: psp back door ring light  (Read 1296 times)

Offline chris69

  • Guppy
  • *
  • Posts: 1
  • Post quality +0/-0
psp back door ring light
« on: October 09, 2008, 09:47:15 PM »
I want to take out the silver ring in the back door of a fat psp and make it clear with leds to light it up.  Whats the best way?  :help: :dntknw:

Offline crazyl69

  • Who Farted ???
  • *
  • Posts: 234
  • Post quality +0/-0
Re: psp back door ring light
« Reply #1 on: October 09, 2008, 11:58:44 PM »
   Welcome to AcidMods Forum. Okay! To begin, there's really no short cut in doing this project. Not recommended for beginers. Psp would have to come apart. Gently remove the two screws thats locking in the buttom hinges of the umd door. With a thin knife or small blade, pry out the umd door. Next, with a heat gun or hair blower, slightly heat up the area of the metal ring to soften up the glue and gently separate. With a dremel tool (highly recommended), cut out the center area in a circular motion. Smooth out the outer area with a fine emery cloth or sand paper and replace it with either a home made plastic see thru window or proffesionally made jewel. From this point on you are going to need Kynar wire, solder gun, glue gun, heat shrink tubes, 10 ohmn resistor and finally, smt 0630 LED's (color of your choice). I hope this helps you out.

Offline Cookie Monster

  • I SMELL SOMETHING
  • CyberPyrot WannaBe
  • *
  • Posts: 303
  • Post quality +6/-0
  • Gender: Male
  • GIMMIE COOKIE
Re: psp back door ring light
« Reply #2 on: October 10, 2008, 02:06:48 PM »

thanks toad and indy for the sigglys

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal