« previous next »
Pages: [1]   Go Down

Author Topic: Question about the 360 controller rol  (Read 1161 times)

Offline xSLICKVICx

  • King of the Wii-tards
  • *
  • Posts: 160
  • Post quality +0/-0
Question about the 360 controller rol
« on: January 15, 2009, 11:41:24 PM »
Hi i have been modding 360 controllers for a good while but i have never swapped the rol leds to red ( i only did to blue) i was wondering since the mobo runs off of 3 volts and the leds forward voltage is around 2.2-2.4 volts, would i have to add resistors? it will be pretty bulky with the resitores inside. if i do need to add resistors can some 1 show me how they added theres?
Logged

Offline Hazer

  • x4675636B4E7574
  • Acidmods Alumni
  • Acid Modder
  • *
  • Posts: 583
  • Post quality +59/-0
Re: Question about the 360 controller rol
« Reply #1 on: January 16, 2009, 04:21:39 PM »
The original green LEDs are the same spec as red LEDs. You do not need to add the resistors if you are doing a direct swap.
Logged
[Quote from Gamermodz via Viking forums]
Don't be jealous your not half as smart. I hate ****tards like you. An ignorant redneck. Your nothing but a posing ******. Get the **** out of here, really, your claim to fame is an open source rapid fire code? You make me laugh. You think you have control over the modding market?  You couldn't create what I can and do. You are too ignorant with your outrageous assumptions and accusations. [/Quote]

Offline xSLICKVICx

  • King of the Wii-tards
  • *
  • Posts: 160
  • Post quality +0/-0
Re: Question about the 360 controller rol
« Reply #2 on: January 17, 2009, 05:46:55 PM »
k thanks that's all i needed to know  :tup:
Logged
Pages: [1]   Go Up
« previous next »
 
SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal