Author Topic: How do you bridge td fuse (Read 1997 times)

Nicbn1 · « **on:** January 30, 2009, 02:41:31 PM »

http://i126.photobucket.com/albums/p113/hardcastle_2006/Td-Fuse.jpg

GhoSt: Please hyperlink URL's using the

button next time

bustinthejustin · « **Reply #1 on:** January 30, 2009, 03:03:04 PM »

Just drop a blob of solder on it. Or you could use a wire and connect each end to each end of the fuse.

RoBot1ks · « **Reply #2 on:** January 30, 2009, 03:12:07 PM »

Use 30guage insulate kynar wire or magnet wire.
Put a bit of flux on each end of the fuse.
Then cut a 1/4-1/2 inch or so piece of wire.
W/ sum skillz, solder each end of the wire to the ends of the fuse.

Good luck

Jumbo · « **Reply #3 on:** January 30, 2009, 03:14:40 PM »

ALSO, make sure you insulate it WELL or it will short out..

I dont suggest the blob of solder i suggest heating it up taking the fuse off and solder a piece of kynar onto the 2 points so its flat enough you can put some tape or hot glue over it

RoBot1ks · « **Reply #4 on:** January 30, 2009, 03:15:39 PM »

Yea thanks Jumbo
I haven't ever gotten the "blob" method to work..

Jumbo · « **Reply #5 on:** January 30, 2009, 03:23:29 PM »

Quote from: RoBot1ks on January 30, 2009, 03:15:39 PM

Yea thanks Jumbo
I haven't ever gotten the "blob" method to work..

If anything it will cause a cone solder joint and it will all go down hill from there lol.

News:

Author Topic: How do you bridge td fuse (Read 1997 times)

Nicbn1

How do you bridge td fuse

bustinthejustin

Re: How do you bridge td fuse

RoBot1ks

Re: How do you bridge td fuse

Jumbo

Re: How do you bridge td fuse

RoBot1ks

Re: How do you bridge td fuse

Jumbo

Re: How do you bridge td fuse