led mods are dim

[atomicareprise]

so this is what i did...i use only one ground that runs to the pobo..

i did not use the ground of the lm386..will this be an issue??

i also noticed that when i remove my speaker connector my light is

bright then i turn it off, then turn it on its dim..then i put back my

speaker connector then its bright again..what is the problem??

[rceckspurt13]

Well your diagram doesn't show a ground of any kind connected to the lm386. I would assume that you grounded the lm386 in the psp right? If not then you need to attach the lower left pin of the lm386 to a ground. That may be the problem.

[atomicareprise]

yep i did not use the ground from the lm386...

can i run it to the same ground to the pobo??

[rceckspurt13]

Yep. But it definately needs to be there for it to work correctly.

[atomicareprise]

thanks...btw is there any issues regarding that i did not use

any resistors to my internal speaker??

i just thought that i'll be needing them if only i have an additional speaker..

[rceckspurt13]

That's true. With LEDs, you don't really need the resistors. I would probably still use them though because you may get a better blink.