Author Topic: Easy LM386N questions  (Read 1011 times)

Offline DLoc

  • ½ Pint
  • *
  • Posts: 38
  • Post quality +0/-0
Easy LM386N questions
« on: March 07, 2009, 06:36:33 PM »
Ok, so I'm working on the sound reactive mod of LOrdNico's. I'm currently waiting for a clear housing to come in the mail, and I was thinking that the black electric tape was a bit of an eyesore. So I was thinking about hot glue, It's clear, and will allow me to see the components. Can I cover the LM386n and resistors in hot glue without side affects? Is hot glue is non-conductive? Will I risk overheating the LM386 when it's powered on? Any advice is greatly appreciated.

Offline bustinthejustin

  • Registered BST
  • E = MC² Mad Scientist
  • *
  • Posts: 2326
  • Post quality +1/-0
  • Gender: Male
Re: Easy LM386N questions
« Reply #1 on: March 07, 2009, 06:42:51 PM »
hot glue should work. It's non-conductive and I don't think it'll affect heat by much. Although if the lm386 get's too hot, the glue will melt... You can always just not cover it. I mean, as long as you isolate it from anything conductive (like maybe cover the mobo near the lm386 with electrical tape) and secure it, it shouldn't short itself out.

Sig by Kenshinffx - Thanks!

Offline Jumbo

  • Dr. Mod
  • BST BAN
  • Around the block
  • *
  • Posts: 2399
  • Post quality +0/-3
Re: Easy LM386N questions
« Reply #2 on: March 07, 2009, 06:55:57 PM »
Hot Glue will be fine :D Its also not that clear you can clearly see it ;)

Offline DLoc

  • ½ Pint
  • *
  • Posts: 38
  • Post quality +0/-0
Re: Easy LM386N questions
« Reply #3 on: March 07, 2009, 07:00:32 PM »
cool thanks. Maybe I'll see if I can get away with just tape then glue on the memory stick holder, and the top exposed.

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal