PSP Wifi LED Trace Gone

[atomicfart3514]

I was trying remove the PSP Memory stick LED with I accidently scraped off the trace for the wifi led. I tried retracing it with solder but the trace is just too small to be precise. Is there some way to connect the LED to the ground origin so it will blink when it should be? Power is not a problem to find.

Any input is helpful.

[MARIOPARTY53]

OK, where the trace is cut off, solder it, so say the positive trace is cut, well where its cut from, scrap a little more off,solder to the place where you scratched with a wire, then connect the wire to the postive on the led, and the negative on the board...  i will make a draeing or something if needed