Author Topic: PSP Wifi LED Trace Gone  (Read 1117 times)

Offline atomicfart3514

  • Guppy
  • *
  • Posts: 6
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
PSP Wifi LED Trace Gone
« on: May 09, 2009, 09:45:19 PM »
I was trying remove the PSP Memory stick LED with I accidently scraped off the trace for the wifi led. I tried retracing it with solder but the trace is just too small to be precise. Is there some way to connect the LED to the ground origin so it will blink when it should be? Power is not a problem to find.

Any input is helpful.

Offline MARIOPARTY53

  • I DONT FAIL
  • BANNED
  • E = MC² Mad Scientist
  • *
  • Posts: 1526
  • Post quality +0/-0
  • Gender: Male
  • Pc Gaming Rules
Re: PSP Wifi LED Trace Gone
« Reply #1 on: May 10, 2009, 12:14:06 AM »
OK, where the trace is cut off, solder it, so say the positive trace is cut, well where its cut from, scrap a little more off,solder to the place where you scratched with a wire, then connect the wire to the postive on the led, and the negative on the board...  :tup: i will make a draeing or something if needed
However today I was brutally raped by a door handle, and none of my friends helped me up off the floor after ten minutes, instead they all teabaged me, all 10 of them...

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal