Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
yes tut links here:Internal go cam:https://www.acidmods.com/forum/index.php?topic=13432.0Disassembling go cam (need for internal one):https://www.acidmods.com/forum/index.php?topic=10580.0and cr-3100 internal photofast:https://www.acidmods.com/forum/index.php?topic=24584.0
Microphone is one the go camso when you internalize it.You'll have the mic.(mic is in the top right corner attached to cam)
you can put the cam in the back of the psp.on the opposite side of the battery.and keep the umd drive.and to keep the usb port you gotta add a switch to Data+ (D+) if you wanna use usb mode.Diagram:
Lol It's not hacking it's modding.but things you will need are:15 watt soldering iron30AWG wire0.015" solderSoldering paste, Flux (not needed but makes it so much easier and recommended).all of this can be found at radio shack.and a slide switch for the usb Data+from mouser.comA psp screwdiver (find a small Phillips head at home depot or somewhere)I'll make a Diagram tomorrow.But what did you not understand?
I'll make a Diagram tomorrow.
No I don't have a go cam. I'll try to make another diagram today.and there's a tutorial on acidmods.
so you get the wiring just not were to put the cam and keep umds?
lol sorryon the usb to camera add a switch to the middle pin (the third one and the yellow wire in This Picture.)and make the wires long enough so you can fit the cam on the case on the opposite side of the battery like in the video.