list of materials
-360 thump sticks
-(opptional) play station thump stick/ mushroom top thumpsticks
-hot glue gun with sticks
-dremel
.cuting disk
.drill tip / sized just alittle bit smaller than thump stick hole
.tool
.sanding tip
-pin niddle
-exacto knife
-sand paper
P.S. i do not recomend the batterie dremal it sucks,but it was $20 and the wired one was $45 so w.e. but its all i got for now
ok now first off we gota cut the top off one of the tops off the thump stick
it should look something like this
this is the bottom part/ the on that goes on the anologe
now sand the top to make it flat and around the stick
the when its all smoth around drill a small hole directly in the middle, just enough so when the glue dries it makes and internal stick for stablity.
ok now that thats done time for the seconend thump stick. i used an old ps2 mushroom pop top, but a 360 will work too.
ok this one is all ready set to go but ill go over the steps
cut the round bottom off but leave the rectangulare circle with the hole
now sand around it to make it smooth
and now thats done, now heat up the hot glue gun
now put in enough hot glue in each hole to where it barly over flows
and then put them together, in this short time move the top thump stick so that its even with the bottom part.
Now let it dry all the way, then put hot glue all around the gap and let it ozzz it is going to be removed later
ok now useing a hobbie knife or exacto knife cut off most of it but dont cut in it
now useing sand paper, i do not recomend the dermal cuse the heat mealts the gule/ friction. just use a strip of sand paper and keep sanding till its good. ok now last step take a neddle and cut it like 3/4 inch long with pintiy tip and then insert it at the bottom all the way in
ok and now just put it in and your done extra senesitvity for sniping or any thing else
the finshed product
ok this is my first mod tut so if its not the right format or somthing i am sorry
