ok so here goes... the psp laptop is only going to have the screen above the umd door. i am currently working on adding a keypad. would be grateful if you could post ideas
I DO NOT TAKEE RESPONSIBILLITY FOR YOUR PSP, IF IT BREAKS DURING DOING THIS IT IS INTIRELY YOUR FAULT.
HERES THE TUTORIAL.
1. Take of you psp faceplate
2. Unclip your screen from the metal piece holding it to the psp
3. then on the top of your psp faceplate, where those little holes are up the top/infront of your umd drive you need to use a knife and cut that top bit of.
4. lift the psp screen up but DO NOT PULL IT AWAY FROM THE MOTHERBOARD!!! then re attach your case--- the bit you cut out should be wide enough for the ribbon cable to fit through.
5. screw it all back together, you made neeed a bit of superglue if neccisary.
6. i just got some black wire tape here and put it round my screen to not only hold it up but also to suport it otherwise i would hyper extend the ribbon cable. i sugggest using wire tape because it looks neater than maybe selotape.
SORRY THE PICTURES ARNT GREAT BE UPLOADING SOME MORE IN A FEW DAYS -.-