Please help support the site by donating at the link below.https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=8ZRU34U47BESW
- Not to sure where else to connect the negative on the motherboard. (just refer to a motherboard screen shot to check where you can find a negative.)- The base is connected to the positive end of the speaker with a 200 ohm resistor.
can i solder the negative to the negative point of the speaker also?
ut when replacing the diode with a wire, I was wrong, I used the wrong transistor.The voltage raises actually to 1.25V ans stays that way. Does that indicate something?
2N2222 and 2N3904 are pretty much the same.
I used an 191K instead of the 220, woopz.
Lol nice one. 191,000 is much different than 220. What happened when you replaced it with the appropriate resistor? I'm just trying to get to the bottom of this problem