Author Topic: Need some help with leds...  (Read 1092 times)

Offline .:M@x!W:.

  • Chief squatting Hard
  • *
  • Posts: 22
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Need some help with leds...
« on: October 20, 2010, 07:29:04 AM »
I already led swapped the ms and wifi led on my psp slim but i wanted to change the power led to but it was a different led than the 0603 ones :S how do i swap the powerled?

Offline l0rdnic0

  • 2%
  • Acidmods Alumni
  • E = MC² Mad Scientist
  • *
  • Posts: 1836
  • Post quality +8/-0
  • Gender: Male
  • TeamCYBER

Re: Need some help with leds...
« Reply #1 on: October 28, 2010, 07:40:57 AM »
I'm sure there is a Tut around here for it. You have three options. Buy a two color LED like it, tin and solder two leds to the 3 contact points or only solder one LED.

Its been so long, but after you desolder the existing led there would be three contacts. Use a meter here because I'm going off my memory and I'm old..... I think the middle pin was ground  and the lower pin was Power (Green) and the top most pin was Orange (Charge)

If your going the SMD route know that the contact points are small, REMEMBER to TIN!  :#1:


L0rdNiC0 Pioneering Mods on the PSP Slim :taunt:
Sound Mod, Button LED Mod, Security Mod, Dual NUB, Mode Select Switch + More

Offline .:M@x!W:.

  • Chief squatting Hard
  • *
  • Posts: 22
  • Post quality +0/-0
  • Gender: Male
  • Acidmods User
Re: Need some help with leds...
« Reply #2 on: October 28, 2010, 10:16:30 AM »
Thanks for replying nic0 u made some amazing mods :) and i'll TIN

 

SMF spam blocked by CleanTalk
SimplePortal 2.3.5 © 2008-2012, SimplePortal