Serg, how did you manage to do this?
1. Download and install MotioninJoy. Get the latest version depending on your operating system.
2. Download this (
http://www.ngohq.com/home.php?page=dseo) and run it. Click "Enable Test mode", then Next.
3. Click Sign System Files, then Next.
4. Use that to sign all files in the C:\Program Files\MotioninJoy\ds3\drivers folder, and in the x64 subfolder.
5. Restart computer. You will now see "Test mode" in the bottom right of your desktop.
Note: steps 6-10 are the same as above... reposted
6. Once started up, plug in your controller. Windows will install some generic driver, which is of no use.
7. Click Start-> Control Panel -> Device Manager.
8. Under Human interface devices, click USB Input Device
Note: There are probably more than one of those. Right click, click Properties, click Details, click Hardware Ids in the drop down menu. It should say "USB\VID_54..."
9. In Properties, click the Driver tab, click Update Driver..., then Browse my computer, then Let Me Pick, then Have Disk...
10. Type or navigate to C:\Program Files\MotioninJoy\ds3\drivers, and click OK.
11. If you've done everything right you should get an "installed correctly" message! Then, click Start, All Programs, MotioninJoy, DS3 Tool. Select the fourth option, click enable, and you can test rumble and configure buttons!
It should work perfectly. To use the controller, you have to run it or you can make windows run it at startup.
Here's my controls (Follows a basic FF setup)
D-Pad: Targeting
Left Analog: Movement
Right Analog: Camera
Start: Emote Menu
Select: Map
PS Button: Ventrilo
O Button: Confirm
X Button: Cancel
Square Button: Active/Passive Mode
Triangle Button: Menu
L1: First Person
L2: Status Tooltips
R2: Macros