error 0110

[eddieluu]

i want to know what is the best way to fix a xbox with error code 0110? i try to reflow the small black block (RAM) with just a heat gun and i still get the same code

[Rodent]

Reflow all the ram chips , and use a griddle will get the one on the bottom side of the board and see if  that helps may have to reflow with no clean flux. if that dont work then they need to be re-balled

[eddieluu]

i did reflow all 8 of the ram chips. can i just place the 360 on top of the griddle without drilling and putting screws through it?

[Rodent]

i did reflow all 8 of the ram chips. can i just place the 360 on top of the griddle without drilling and putting screws through it?

Here are some pics of how i set mine up works good all the time follow this tutorial
read this you will see  pics how i set it up
https://www.acidmods.com/forum/index.php/topic,37530.30.html

[eddieluu]

do i have to get the rework station just to do the reflow or the heat gun is good enough. im going to get a griddle to try it

[Rodent]

do i have to get the rework station just to do the reflow or the heat gun is good enough. im going to get a griddle to try it

I use a heat gun around 500 degrees and keep it about 1" (inch) to 1 1/2 " (inches) above the board.
 
board ruffly gets  about 380 degrees becarefully  and set the griddle at 400 degrees . I got Ryobi heat gun veriable heat range 200 to 1100 paid $ 60.00 usdolllars at home depot

[eddieluu]

i got a heat the only got two setting high and lo. when i am reflowing how long should i heat up the the ram chip and how should i reflow the chip on the bottom of the board

[Rodent]

i got a heat the only got two setting high and lo. when i am reflowing how long should i heat up the the ram chip and how should i reflow the chip on the bottom of the board

the ones on the bottom should heat up enough from the griddle and i  wouldnt stay on them any longer then about 3 or 4 minutes i would work it around them all in circular motion around all 4 chips at the  max 4 minutes over the whole area of the  chips dont stay and do  just one do all 4 together, get it too hot and the ram chips could come off use a thermal temp gun also to keep a eye on how hot your getting the board

EDIT: I  have helped alot of people on here and they havent had any problems reflowing with my instructions, takes some common sence watch what your doing. Not resposible if you do it longer or hold it closer then i said, if you dont know something ask first. Its a chance everyone takes when re-flowing there own board.

[eddieluu]

one last thing do i need to use no clean flux one the ram chip and do i put it on each one?

[Rodent]

would use a eye dropper and let it run under the chips and whip off the excess flux when it runs out,

its No Clean Flux should be liquid, might be able to do it with out the flux hopefully they dont need to be re-balled