Havent been on here in along time
I have looked for answer and really no one can help me on this, its kind of wierd
I searched on this forum and looked through many threads but no one can give me an answer.
I have wired my pulseVU2 properly with the momentary push switch connected on the +pad and the SW pad, from the SW i connected a 10kOhm resister to the -pad on the PulseVU2.
As indicated on this photo
I have the OP wired to a bipolor slide switch. Its set on off for now so i can go through the fade modes and dimmer.
And connected two 5mm White LED with a 150Ohm resister and connected + end to the ps3 mobo and the - end to the VU on the pulse2 chip.
My forward voltage is 5v on the Ps3 board. Using the powersupply connection on the mobo.
When i turn on the ps3 and wait for the Pulse2 i see a dime light of my test LED but it quickly fades out.
When i hold the momentary push switch the LED begin to fade in mode 1, But when i release it stops.
Do i have the momentary push switch polarity backwards?
